DIP MATTE VOLK BRONZE

APPLICATION INSTRUCTIONS
Use adequate ventilation.
Surface must be clean and dry. For best results clean with rubbing alcohol, avoid sunlight, high humidity, or breezy conditions.
Use only when temperature of material and surfaces are between 20°C and 28°C.
1. Shake can vigorously for one full minute after mixing ball begins to rattle. Shake often while applying.
2. Hold can 8 to 12 inches from surface. Move can back and forth slightly overlapping each stroke, applying thick enough to produce an even, wet appearance.
3. Allow 15-20 minutes minimum between coats or until dry. Apply as many coats as desired (3-4 average).
Coverage: 0.37161 square meters (4 sq. ft.) or one rim per can (minimum 4 coats for better coverage and easy removal).

Coats, seals, protects and can be used on metal, wood, glass, rubber, concrete, fabrics, fiberglass, rope, etc.

TECH TIPS
Always protect surrounding areas from overspray.
Allow 1 hour away from dust to dry and 5-6 hours to dry completely.
If runs or sags are experienced, move can further away from surface or make sure the temperature of the object is between 20°C and 28°C (68°F and 82°F).
To avoid clogged nozzle, turn can upside down and spray for 5 seconds. If clogged, remove nozzle and soak in naphtha or mineral spirits for 30 minutes.
Do not stick pins or other objects into stem.
Use naphtha, xylene (xylol), or toluene (toluol) for clean-up.